how to install wall to wall carpet

how to install wall to wall carpet::This is pretty easy, but make sure that you remove all of the moldings and take the door out of the doorway first.
After you do this, vacuum the carpet to get as much dust up as possible.
This will keep the air in your home cleaner while you work.
Then, cut the carpetting into strips and then roll it up.
This is the easiest way to transport the old carpet as well.
You will also need to make sure that you get rid of the underlay as well.
Carpet is not dust, dirt, or waterproof, so most of what has been getting into the carpet or spilled onto it will also drip down into the underlay.
Additionally, if there are wear patterns on your carpet from the places where people walk the most, then those patterns will probably also appear on the underlay.
After you take up the underlay, you should clean your subfloor.
You can also take the time to make sure that all of your floorboards are nailed down correctly.
There will probably be seams between the pieces of new underlay.
If this is the case, then you should seal these seams off with duct tape.
Since you want to lay walltowall carpet, you need to start with a piece of carpet that is a few inches larger than the space you want to cover with carpet you should have about 5 inches of extra carpet.
This will make sure that your carpet does not come up at the walls, or get pulled into the middle of the room through wear and tear.
Make sure that your carpet is going to overlap by a few inches where you have that seam, and put a piece of adhesive down to make sure that the carpet pieces will stay together.
Finally, make sure that you use a knee kicker and a carpet stretcher to stretch the carpet over the tackless strips.
Now all you have to do is replace your door and moldings.
About the author get home design and decorating ideas by watching homes from all over the world please visit article source:

Ronkainen Hester Damsdorf blog

четверг, 29 сентября 2011 г.